Edimax-technology PS-1206MFG Manuel d'utilisateur télécharger pdf (Page 58)

configure the wireless function.

Auto – “Auto” is the default setting of the MFP Server. At this mode, the MFP

Server will automatically decide to enable or disable the wireless function.

When the MFP Server starts up, it will auto-detect if the LAN port is connected

to an active network by an Ethernet cable. If this is the case, the MFP Server

will run in Ethernet mode. If the MFP Server is not connected to an active

network by Ethernet cable, the MFP Server will run in wireless LAN mode.

Users can plug the Ethernet cable to the MFP Server at the first, after

configuring the MFP Server features and wireless settings; they can unplug

the Ethernet cable to enable the wireless connection. It makes the

configuration much easier without creating the wireless connection in

advance.

Note: After you have set the wireless function, please remove the Ethernet

cable and then re-plug the power jack of the MFP Server to activate the

wireless connection.

Enable – Enable wireless function only, the MFP Server’s wireless LAN will

be always enabled and Ethernet will be always disabled.

Disable – Disable the wireless function, the MFP Server’s wireless LAN will

be always disabled and Ethernet will be always enabled.

Domain Country: The wireless channels are different from country to country.

Generally, the channels are from 1 to 11 in USA and from 1 to 13 in Europe.

The operating channel will be set to the MFP Server before importing. If you

are in different country, please make sure that you have set the available

channels according to your location.

7.8 Wireless Configuration

If you want to use the MFP Server through wireless LAN, please set up the

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 141 142

Pas de commentaire

Edimax-technology PS-1206MFG Manuel d'utilisateur Page 58