Edimax-technology Edimax user guide Router Manuel d'utilisateur télécharger pdf (Page 10)

Page 6

Rear Panel

Figure 1-2: Rear Panel

DC 5V

Connect the supplied power adapter here.

WAN 2

Connect the 2

Broadband Modem here, if available.

Reset Button

When pressed and released, The Load Balancer will reboot (restart) within 1

second. It resets to default over 3 seconds.

LAN Ports

Connect the PCs to these ports. Both 10BaseT and 100BaseT connections can

be used simultaneously.

Note:

Any port will automatically operate as an "Uplink" port if required. Just use a

normal LAN cable to connect to a normal port on another hub.

WAN 1

Connect the primary Broadband Modem here.

Default Settings

When The Load Balancer has finished booting, all configuration settings will be set to the factory

defaults, including:

• IP Address set to its default value of 192.168.1.1, with a Network Mask of 255.255.255.0

• DHCP Server is enabled

• User Name: admin

• Password cleared (no password)

TFTP Download

This setting should be used only if your Load Balancer is unusable, and you wish to restore it by

downloading new firmware. Follow this procedure:

1. Power On The Load Balancer.

2. Use the supplied Windows utility or a TFTP client program applies the new firmware. If using the

supplied Windows TFTP program, the screen will look like the following example.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 80 81

Pas de commentaire

Edimax-technology Edimax user guide Router Manuel d'utilisateur Page 10