Edimax-technology ER-5390S Manuel d'utilisateur

DIMAXEthernet HubER-5390S9-Port DesktopEthernet HubUser ’ s ManualSSLANPROFEIONAL

4. Connecting to network devices with coaxial cablesAttach the T-connector to the BNC port on the rear panel and connect the coaxialcables to the both

66Trouble-shooting1. Power LED is not litl Check if the external power adapter is plugged into the power outlet. Make sure the DC power jack is f

5. Collision LED is constantly flashingl Remove all the network cables; connect the cables back one by one to isolate the source of the collision.

This equipment generates and uses radio frequency energy and if not installedand used properly, that is, in strict accordance with the instructions pr

Chapter 1 Introduction ...1Chapter 2 Features & Specifications ...2Chapter 3 Package Contents ...

11IntroductionCongratulations on your purchase of Edimax’s 9-port desktop Ethernet 10Base-Thub - ER-5390S. This hub is specifically designed to prov

22Features & Specifications(1) Featuresn Comply with IEEE 802.3 10Base-2 and 10Base-T Ethernet Standards.n Support eight RJ-45 connectors for 10Ba

33Package Contentsn 9-port desktop Ethernet Hubn One external power adaptern One T-Connectorn User’s manual3Figure 3-1 Package contentsPowerCollision

PowerCollisionLNK/RxPartitionRx9-Port 10Mbps Ethernet Hub1 BNCDIMAX2 3 4 5 6 7 8LANPROFESSIONLPartition44Physical Description(1) Panel4 Figure 4-1 Pan

Partition(BNC Port)Act(BNC Port)GreenRedOffLitOffFlash Data packets receivedNo activityNo coaxial cable attachedCable attached(1) LED5LED Color Status

55Installation1. Operating EnvironmentER-5390S must be installed and operated within the limits of specified operatingtemperature and humidity (see pr